LaunchMicro

Sections

Personal tools

You are here: Home → Public Information → V-COM Basic → Introduction to MicroManufacturing Processes → Introduction to Micromilling Processes → Knowledge Assessment

Log in: Login Name

Password

Cookies are not enabled. You must enable cookies before you can log in.; Forgot your password?

Knowledge Assessment

Automatically check how much have you learnt from the text

Question 1/4

What type of parts is micromilling suitable for?

Profiled parts

Conical parts

Spherical parts

Complex 3D parts

Any type of part

Question 2/4

How are the cutting forces with regards to the forces in the traditional processes?

Higher

Equal

Lower

Question 3/4

Another very important issue in micromilling is?

Maximum chip thickness

Minimum chip thickness

Minimum chip height

Maximum chip curl

Question 4/4

What is the matter with cutting tool tolerances?

They are much smaller than tool geometry

Tolerances are of the same order as geometry

There is no matter

This site conforms to the following standards: